Siemens Hicom 112

A31003-K16-X001-3-7620, 07/99
Hicom 100 E Version 2.1
,
Service manual
Z-7
Index
music on hold (MOH) 10-57
night service (as of SW version 2.0.2)
10-64
signal key mode (as of SW version
2.0.2) 10-64
telephone directory 10-57
Programming ISDN lines 10-1
Programming sensors 10-78
assigning sensor names 10-82
defining call duration 10-80
defining the call interval 10-81
defining the destination number 10-78
defining the disable time 10-81
defining the number for recorded an-
nouncement device 10-79
defining voice mail control data 10-79
Programming the fax/DDI module 10-82
allocating to a line 10-85
defining analogue access for each option
10-84
defining the fax destination 10-86
defining the number of announcement
without notification options (as of SW ver-
sion 2.02) 10-84
defining the number of DDI options 10-
83
defining the number of fax options 10-83
defining the number of fax/DDI options
10-83
initialising the fax/DDI module 10-86
recording announcements 10-87
PSU/UPS circuitry 3-35
PSU1/UPS1 power supply 5-3
PSU2/UPS2 power supply 5-3, 12-20
PSU3/UPS3 power supply 12-19
Q
Q-Sig networking 4-13
R
Reference to call destination lists 6-6
Re-initialising 6-3
Re-initialising in the case of option expansi-
ons 6-3
Re-initialising in the case of system expansi-
ons 6-3
Remote maintenance of LCR functions 8-7
Repair 9-1
Rerouting 10-8
active rerouting 10-8
changing a route 10-9
Route codes 6-15
Route names 6-15
S
Screw terminals 3-36
Selecting the most suitable location 5-1
Serial interface board (SIB) (V.24 connection)
3-22
Setting call charges in Caracas Desk with
password 11-20
Setting the door opener 10-27
Controlling the door opener via a door
opener adapter (as of SW version 2.0.2)
10-28
Controlling the door opener with a door
opener adapter (up to SW version
2.0.1+) 10-27
controlling the door opener with actuators
10-27
Diverting calls to receiving extension for
the doorbell (as of SW version 2.0.2) 10-
28
DTMF release class of service 10-29
Setting up and initial operation of Caracas
Desk 11-16
SIB (serial interface board) - interfaces 3-22
Signalling method 8-6
Single-stage LCR 8-3
SLAS interfaces 3-15, 3-16
SLU8 interfaces 3-17
Spare parts 9-1
Specific 4-15
Specific seizure with existing DDI number 4-
15
Standard extension number plans 3-6
Standard numbering of the MB modules 3-6
Standard numbering, MB 2/4 Hicom 108 3-6
Standard numbering, MB 2/4 Hicom 108 (SW
2.0.1) 3-6