Appendix E: Search and Trigger Command Sequence Examples
Command Comment
:SEARCH:SEARCH1:TOTal? Returns 3 or 4, indicating 3 or 4 times when one of channels
1, 2 or 3 became high.
Note: Dependi
ng upon the number of transitions displayed,
you may get 3 or 4 search marks for this example. If you get
3 search marks, try adjusting the horizontal position until you
see 4 search m
arks.
:SEARCH:SE
ARCH1:LIST?
Returns a li
st of 3 marks on 3 waveforms:
CH1,24.1600,24.1600,24.1600,1.0336E3,0.0E+0,0.0E+0,
0.0E+0;CH2,24.1600,24.1600,24.1600,1.0336E3,0.0E+0,
0.0E+0,0.
0E+0;CH3,24.1600,24.1600,24.1600,1.0336E3,
0.0E+0,0.0E+0,0.0E+0;CH1,50.0000,50.0000,50.0000,0.0E+0,
0.0E+0,0.0E+0,0.0E+0;CH2,50.0000,50.0000,50.0000,
0.0E+0,0.
0E+0,0.0E+0,0.0E+0;CH3,50.0000,50.0000,50.0000,0.0E+0,
0.0E+0,0.0E+0,0.0E+0;CH1,75.8300,75.8300,75.8300,
1.0332E3,0.0E+0,0.0E+0,0.0E+0;CH2,75.8300,75.8300,75.8300,1.0332E3,
0.0E+0,0
.0E+0,0.0E+0;CH3,75.8300,75.8300,75.8300,1.0332E-3
,0.0E+0,0.0E+0,0.0E+0
E-4 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
