Commands listed in alphabetical order
Arguments
PLL specifies us
ing the phase locked loop.
CONSTANTCLOCK specifies using a constant clock.
EXPLICITCLOCK specifies using an explicit clock.
Examples
MEASUREMENT:CLOCKRECOVERY :METHOD EXPLICITCLOCK specifies using
an explicit clock.
MEASUREMENT:CLOCKRECOVERY :METHOD? might return
:MEASUREMENT:CLOCKRECOVER Y:METHOD PLL indicating the
method is set to PLL.
MEASUrement:CLOCKRecovery:MODel
This command sets or queries the global phase locked loop (PLL) clock recovery
model used when PLL cloc k recovery is used for the measurement. This will affect
measurements whose :MEASUrement:MEAS<x>:CLOCKRecovery:GLOBal
flag is set to 1.
Group
Measurement
Syntax
MEASUrement:CLOCKRecovery :MODel {TYPE1|TYPE2}
MEASUrement:CLOCKRecovery :MODel?
Arguments
TYPE1 PLL clock recovery uses PLL model type I.
TYPE2 PLL clock recovery uses PLL model type II.
Examples
MEASUREMENT:CLOCKRECOVERY :MODEL T YPE2 sets the model to type 2.
MEASUREMENT:CLOCKRECOVERY :MODEL? might return
:MEASUREMENT:CLOCKRECOVER Y:MODEL TYPE1 indicating the
recovery model is type 1.
MEASUrement:CLOCKRecovery:NOMINALOFFset
This command sets or queries the g lobal offset value used when explicit clock
recovery is used for the measurement. This will affect measurements whose
:MEASUrement:MEAS<x>:CLOCKRecovery:GLOBal flag is set to 1.
Group
Measurement
2-398 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
