Tektronix MSO56 User Manual

Commands listed in alphabetical order
TRIGger:{A|B
}:BUS:B<x>:MIL1553B:STATu s:BIT:INSTR
This command sets or queries the value of the instrumentation bit (INSTR bit, bit
10) in a status word for a MIL-STD-1553 bus to triggering on. The bus number is
specified by x
. The trigger condition must be set to STATus.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:MIL 1553B:STATus:BIT:INSTR
{ONE|ZERo|NOCARE}
TRIGger:{A|B}:BUS:B<x>:MIL 1553B:STATus:BIT:INSTR?
Arguments
ONE filters status words to only match those where the INSTR bit has a value of 1.
ZERo filters status words to only match those where the INSTR bit has a value of 0.
NOCARE disables filtering of status words on the INSTR bit.
Examples
TRIGGER:A:BUS:B1:MIL1553B: STATUS
:BIT:INSTR ONE
specifies filtering
status words for those where the INSTR bit has a value of 1.
TRIGGER:A:BUS:B1:MIL1553B: STATU
S:BIT:INSTR?
might return
NOCARE, indicating that status words are not being filtered based on the INSTR
bit value.
TRIGger:{A|B}:BUS:B<x>:MIL155
3B:STATus:BIT:ME
This command sets or queries the value of the message error bit (ME bit, bit 9)
in a status word for a MIL-STD-1553 bus to triggering on. The bus number is
specified by x. The trigger condi
tion must be set to STATus.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:MIL 1553B:STATus:BIT:ME
{ONE|ZERo|NOCARE}
TRIGger:{A|B}:BUS:B<x>:MIL 1553B:STATus:BIT:ME?
MSO54, MSO56, MSO58, MSO58LP Programmer 2-825

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English