Tektronix MSO56 - TRIGger:{A|B}:BUS:B<x>:FLEXray:EOFTYPE

Commands listed in alphabetical order
Conditions
Requires the SR
-AUTO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:FLE Xray:DATa:VALue <QString>
TRIGger:{A|B}:BUS:B<x>:FLE Xray:DATa:VALue?
Arguments
<QString> is a quoted string.
Examples
TRIGGER:A:BUS:B1:FLEXRAY:D ATA:VALUE "11001101" sets the FlexRay
data value for triggering to
11001101.
TRIGGER:A:BUS:B1:FLEXRAY:D ATA:VALUE? might return
TRIGGER:A:BUS:B1:FLEXRAY:D ATA:VALUE "XXXXXXXX" indicating the
FlexRay data value is don't care.
TRIGger:{A|B}:BUS:B<x>:FLEXray:EOFTYPE
This command specifies the end of file type (static, dynamic or any) when
triggering on the FlexRay bus EOF field. The trigger condition needs to be set
to EOF (using TRIGger:{A|B}:BUS:B<x>:FLEXray:CONDition). The bus
number is specified by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:FLE Xray:EOFTYPE {STATic|DYNAMic |ANY}
TRIGger:{A|B}:BUS:B<x>:FLE Xray:EOFTYPE?
Arguments
STATic specifies triggering on the STATIC end of file type.
DYNAMic specifies triggering on the D YNAMIC end of file type.
ANY specifies triggering on a STATIC or DYNAMIC end of file type.
Examples
TRIGGER:A:BU
S:B1:FLEXRAY:EOFTYPE ANY
sets the FlexRay end of file
type to ANY.
TRIGGER:A:BUS:B1:FLEXRAY:E OFTYPE? might return
TRIGGER:A:BUS:B1:FLEXRAY:E OFTYPE STATIC indicating the
FlexRay end of file type is STATIC
MSO54, MSO56, MSO58, MSO58LP Programmer 2-799