Commands listed in alphabetical order
BUS:B<x>:USB
:SOUrce:DMINus
This command sets or queries the USB D- (SDATAMINUS) source for bus <x>
when the signal type is single ended. The bus number is specified by <x>.
Conditions
Requires option SR-USB2.
Group
Bus
Syntax
BUS:B<x>:USB:SOUrce:DMINus
{CH<x>|CH<x>_D<x>|MATH<x>| REF<x>|REF<x>_D<x>}
BUS:B<x>:USB:SOUrce:DMINus ?
Related Commands
BUS:B<x>:USB:SOUrce, BUS:B<x>:USB:SOUrce:DPLUs, BUS:B<x>:USB:
SIGNALTYpe
Arguments
CH<x> specifies an analog channel as the D- source for the specified USB bus.
CH<x>_D<x> specifies a digital channel as the D- source for the specified USB
bus.
MATH<x> specifies a math channel as the D- source for the specified USB bus.
REF<x> specifies a reference waveform as the s ource
REF<x>_D<x> specifies a digital reference waveform as the clock source
waveform for the specified USB bus.
Examples
BUS:B1:USB:SOURCE:DMINUS CH2 sets the USB Data Source for D- input
to CH2.
BUS:B1:USB:SOURCE:DMINUS? might return :BUS:B 1:USB:SOURCE:DMINUS
CH4
, indicating that CH4 is set to be the D- input for USB data.
BUS:B<x>:USB:SOUrce:DPLUs
This command sets or queries the USB dataPlus (SDATAPLUS) source for the
specified bus when the signal type is single ended. The bus is specified by x.
Conditions
Requires option SR-USB2.
Group
Bus
MSO54, MSO56, MSO58, MSO58LP Programmer 2-181
To Next Page
Loading...
Need help?
General
