Commands listed in alphabetical order
Syntax
BUS:B<x>:PARa
llel:CLOCkSOUrce
{CH<x>|CH<x>_D<x>|MATH<x>| REF<x>|REF<x>_D<x>|NONE}
BUS:B<x>:PARallel:CLOCkSOU rce?
Related Commands
BUS:B<x>:PARallel:CLOCk:ISCLOCKED,
Arguments
CH<x> specifies an analog FlexChannel to use as the bus clock source.
CH<x>_D<x> specifies a digital channel on
aspecified FlexChannel to use as
the bus clock source.
MATH<x> specifies the math channel to use as the bus clock source.
REF<x> specifies the reference channel to use as the bus clock s ource.
REF<x>_D<x> specifies a digital reference waveform as the clock source
waveform for the specified parallel bus.
NONE specifies the reference cha nnel to use as the bus clock source.
Examples
BUS:B1:PARALLEL:CLOCK:SOUR CE CH3_D6 sets the Parallel clock source for
the bus B1 to D6 of FlexChannel 3.
BUS:B1:PARALLEL:CLOCK:SOUR CE? might return
:BUS:B1:PARALLEL:CLOCK:SOU RCE CH8_D9, indicating that the Parallel
clock s ource f or the bus B1 is set to D9 of FlexChannel 8.
BUS:B<x>:PARallel:CLOCKSOUrce:THReshold
This command sets or queries the clock source threshold for the parallel bus. The
bus is specified by x.
Group
Bus
Syntax
BUS:B<x>:PARallel:CLOCKSOU rce:THReshold <NR3>
BUS:B<x>:PARallel:CLOCKSOU rce:THReshold?
Related Commands
BUS:B<x>:PARallel:CLOCk:ISCLOCKED,
Arguments
<NR3> is the clock bit source threshold for the parallel bus.
Examples
BUS:B4:PARALLEL:CLOCKSOUrc e:THRESHOLD 1.5 sets the threshold of the
clocksourceofparallelBus4to1.5V.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-163
To Next Page
Loading...
Need help?
General
