To Next Page

To Previous Page

Commands listed in alphabetical order

CH2:LABEL:XPO

might return :CH2:LABEL:XPOS 5, indicating that the

waveform label for the Channel 2 currently 5 pixels to the right of the left edge

of the screen.

CH<x>:LABel

:YPOS

This command sets or queries the Y-position of the speciﬁed channel label. The

channel is speciﬁed by x.

Gro

Vertical

Syntax

CH<x>:LABel:YPOS <NR3>

CH<x>:LABel:YPOS?

Arguments

<NR3> is the location (in pixels) where the waveform label for the selected

channel is displayed, relative to the baseline of the waveform. Positive values are

above the baseline and negative values a re below.

Examples

CH3:LABEl:YPOS -20 moves the waveform label for the Channel 3 20 pixels

below the baseline of the waveform.

CH2:LABEl:YPOS? might return :CH2:LABEL:YPOS 0, indicating that the

waveform label for the Channel 2 is currently located at the baseline of the

waveform.

CH<x>:OFFSet

This command sets or queries the vertical offset for the speciﬁed analog channel.

The channel is speciﬁed by x.

Group

Vertical

Syntax

CH<x>:OFFSet <NR3>

CH<x>:OFFSet?

Arguments

<NR3> is the offset value for the speciﬁed channel.

2-194 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO56 User Manual

Questions and Answers: