Commands listed in alphabetical order
Examples
BUS:B1:FLEXra
y:TXRXTHRESHold 50.0e-3
setsthethresholdto50mV.
BUS:B1:FLEXray:TXRXTHRESH old? might return
:BUS:B1:FLEXRAY:TXRXTHRES HOLD 0.0E+0 indicating the threshold is
set to 0.0 V.
BUS:B<x>:I2C:CLOCk:SOUrce
This command sets or queries the I2C clock (SCLK) source for the specified
bus. The bus is specified by x.
Conditions
Requires option SR-EMBD.
Group
Bus
Syntax
BUS:B<x>:I2C:CLOCk:SOUrce
{CH<x>|CH<x>_D<x>|MATH<x> |REF<x>|REF<x>_D<x>}
BUS:B<x>:I2C:CLOCk:SOUrce ?
Related Commands
BUS:B<x>:I2C:DATa:SOUrce, BUS:B<x>:I2C:RWINADDR
Arguments
CH<x> specifies an analog channel to use as the I2C SCLK source.
CH<x>_D<x> specifies a digital channel to use as the I2C SCLK source.
MATH<x> specifies a math waveform to use as the I2C SCLK source.
REF<x> specifies a reference waveform to use as the I2C SCLK source.
REF<x>_D<x> specifies a digital reference waveform as the c lock source
waveform for the specified I2C bus.
Examples
BUS:B1:I2C:CLOCK:SOURCE CH1 sets the I2C SCLK source to CH1.
BUS:B1:I2C:CLOCK:SOURCE? might return : BUS:B1:I2C:CLOCK:SOURCE
CH4_D5
, indicating that the I2C SCLK source is set to D5 of FlexChannel 4.
BUS:B<x>:I2C:CLOCk:THReshold
This command sets or queries the I2C Clock (SCLK) source threshold for the
specified bus. The bus is specified by x.
Conditions
Requires option SR-EMBD.
2-144 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
