Commands listed in alphabetical order
Arguments
FALL specifies p
olarity as the clock falling edge.
RISe specifies polarity as the clock rising edge.
Examples
TRIGger:A:SETHold:CLOCk:ED GE RISE specifies the polarity as the clock
rising edge.
TRIGger:A:SETHold:CLOCk:ED GE? might return
:TRIGGER:A:SETHOLD:CLOCK:E DGE RISE indicating that polarity is specified
as the clock rising edge.
TRIGger:{A|B}:SETHold:CLOCk:SOUrce
This command specifies the clock source for the setup and hold triggering. You
cannot specify the same source for both clock and data.
Group
Trigger
Syntax
TRIGger:{A|B}:SETHold:CLOC k:SOUrce {CH<x>|CH<x>_D<y >}
TRIGger:{A|B}:SETHold:CLOC k:SOUrce?
Arguments
CH<x> specifies the analog channel to use as the clock source waveform.
CH<x>_D<y> specifies the digital channel to use as the clock source waveform.
Examples
TRIGger:A:SETHold:CLOCk:SO Urce CH1 specifies channel 1 as the clock
source for a setup and hold trigger operation.
TRIGger:A:SETHold:CLOCk:SO Urce? might return
:TRIGGER:A:SETHOLD:CLOCK:S OURCE CH4 indicating that channel
4 is the clock source for a setup and hold trigger o peration.
TRIGger:{A|B}:SETHold:HOLDTime
This command specifies the hold time for setup and hold violation triggering.
This command is equivalent to selecting Setup/Hold Setup from the Trig menu
and then setting the desired Hold Time.
Group
Trigger
MSO54, MSO56, MSO58, MSO58LP Programmer 2-863
To Next Page
Loading...
Need help?
General
