Commands listed in alphabetical order
Syntax
MEASUrement:L
OCKRJ
{<NR1>|OFF|ON}
MEASUrement:LOCKRJ?
Arguments
ON indicates that RJ locking is active.
OFF indicates that RJ locking is off.
<NR1> a 0 turns off RJ locking; any other value activates RJ locking.
Examples
MEASUREMENT:LOCKRJ ON activates RJ locking
MEASUrement:LOCKRJValue
This command sets or queries the RJ lock value.
Group
Measurement
Syntax
MEASUrement:LOCKRJValue <NR3>
MEASUrement:LOCKRJValue?
Arguments
<NR3> default value = 1e-12; minimum value = 1e-15; maximum value = 1.
Examples
MEASUREMENT:LOCKRJVALUE 1 sets the lock value to the maximum value of 1.
MEASUREMENT:LOCKRJVALUE? might return :MEASUREMEN T:LOCKRJVALUE
1.0000E-12
, indicating the lock value is set to the default value of 1 e-12.
MEASUrement:MATH<x>:REFLevels:ABSolute:FALLHigh
This command sets or queries the value used as the high reference level of the
falling edge when the measurement ref level method is set to absolute. The math
number is specified by x.
Group
Measurement
Syntax
MEASUrement:MATH<x>:REFLe vels:ABSolute:FALLHigh <N R3>
MEASUrement:MATH<x>:REFLe vels:ABSolute:FALLHigh?
Arguments
<NR3> is the high reference level, and is the zero percent level when
MEASUrement:IMMed:REFLevel:METHod is set to Absolute.
2-410 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
