Tektronix MSO56 - SEARCH:SEARCH<x>:TRIGger:A:BUS:USB:SPLIT:SE:VALue

Commands listed in alphabetical order
SSPLIT specifie
s Start (SSPLIT) (0) Start/Complete value.
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:USB:SPLIT:SC:VALUE DO NTCARE sets
the Start/Complete value for USB bus trigger search 1 to DONTCare.
SEARCH:SEARCH2:TRIGGER:A: BUS:USB:SPLIT:SC:VALUE? might return
:SEARCH:SEARCH2:TRIGGER:A :BUS:USB:SPLIT:SC:VALUE S SPLIT,
indicating that the Start/Complete value for USB bus trigger search 2 is set to
SSPLIT.
SEARCH:SEARCH<x>:TRIGger:A:BUS:USB:SPLIT:SE:VALue
This command sets or queries the Start/End value for the specified USB bus
trigger on split token field search to determine where to place a mark. The search
number is specified by <x>.
Conditions
Requires the SR-USB2 Serial Triggering and Analysis Application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:USB:SPLIT:SE:VALue
{NOCARE|FULLSPEED|ISOALL| ISOEND|ISOMID|ISOSTART|LOWSPEED}
SEARCH:SEARCH<x>:TRIGger: A:BUS:USB:SPLIT:SE:VALue?
Arguments
NOCARE specifies Don’t Care (X) Start/End bit value.
FULLSPEED specifies Control/Bulk/Interrupt Full Speed device (0X) Start/End
bit value.
ISOALL specifies Isochronous Data is All (11) Start/End bit value.
ISOEND specifies Isochronous Data is End (01) Start/End bit value.
ISOMID specifies Isochronous Data is Middle (00) Start/End bit value.
ISOSTART specifies Isochronous Data is Start (10) Start/End bit value.
LOWSPEED specifies Control/Bulk/Interrupt Low Speed device (1X) Start/End
bit value.
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:USB:SPLIT:SE:VALUE IS OSTART sets
the Start/End value for USB bus trigger on split token fieldsearch1toISOSTART.
SEARCH:SEARCH1:TRIGGER:A: BUS:USB:SPLIT:SE:VALUE? might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:USB:SPLIT:SE:VALUE D ONTCARE,
2-712 MSO54, MSO56, MSO58, MSO58LP Programmer