Commands listed in alphabetical order
Group
Status and Erro
r
Syntax
DESE <N R1>
DESE?
Related Commands
*CLS, *ESE, *ESR?, EVENT?, EVMsg?, *SRE, *STB?
Arguments
<NR1> The binary bits of the DESER are set according to this v alue, which ranges
from 1 through 255. For example, DESE 209 sets the DESER to the binary value
11010001 (that is, the most significant bit in the register is set to 1, the next most
significant bit to 1, the next bit to 0, etc.).
The power-on default for DESER is all bits set if *PSC is 1. If *PSC is 0, the
DESER maintains the previous power cycle value through the current power cycle.
NOTE. Setting the DESER and ESER to the same value allows only those codes
to be entered into the Event Queue and summarized on the ESB bit (bit 5) of the
Status Byte Register. Use the *ESE command to set the ESER.
Examples
DESE 209 sets the DESER to binary 11010001, which enables the PON, URQ,
EXE and OPC bits.
DESE? might return :DESE 186, showing that the DESER contains the binary
value 10111010.
DIAg:LOOP:OPTion
This command sets or queries the type of looping desired.
Group
Self Test
Syntax
DIAg:LOOP:OPTion {FAIL|ONCE|ALWAYS| ONFAIL|NTIMES}
DIAg:LOOP:OPTion?
Arguments
Fail - run until a failure is found, then halt.
Once - run through one loop.
Always - run forever.
Onfail - run until a failure is found, then loop on it.
Ntimes - run n number of loops.
2-222 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
