To Next Page

To Previous Page

Commands listed in alphabetical order

MEASUREMENT:C

H2:REFLEVELS:BASETOP?

might return

:MEASUREMENT:CH2:REFLEVELS :BASETOP AUTO indicating the

reference levels a re chosen automatically.

MEASUrement

:CH<x>:REFLevels:METHod

This command sets or queries the method used to calculate reference levels for the

measurement. The channel number is speciﬁed by x.

Group

Measurement

Syntax

MEASUrement:CH<x>:REFLevel s:METHod {PERCent|ABSolut e}

MEASUrement:CH<x>:REFLevel s:METHod?

Arguments

PERCent speciﬁ es percent reference level units.

ABSolute speciﬁ es absolute reference level units.

Examples

MEASUREMENT:CH2:REFLEVELS: METHOD PERCENT sets reference levels to be

calculated in percent.

MEASUREMENT:CH2:REFLEVELS: METHOD? might return

:MEASUREMENT:CH2:REFLEVELS :METHOD PERCENT indicating the

reference levels are calculated in percent.

MEASUrement:CH<x>:REFLevels:PERCent:FALLHigh

This command sets or queries the percentage (where 100% is equal to TOP and

0% is equal to BASE) used to calculate the high reference level of the falling

edge when the source ref level method is set to percent. The channel number

is speciﬁed by x.

Group

Measurement

Syntax

MEASUrement:CH<x>:REFLevel s:PERCent:FALLHigh <NR3>

MEASUrement:CH<x>:REFLevel s:PERCent:FALLHigh?

Arguments

<NR3> isthepercentage(where100%isequal to TOP) used to calculate the hig

reference level when the measurement's Ref l evel method is set to Percent.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-387

Tektronix MSO56 User Manual

Questions and Answers: