Tektronix MSO56 User Manual

Commands listed in alphabetical order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:BUS:MIL1553B:C OMMAND:ADDRess:
HIVALue
<QString>
SEARCH:SEARCH<x>:TRIGger: A:BUS:MIL1553B:COMMAND:ADDRess:
HIVALue?
Arguments
<QString> is the address value.
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:MIL1553B:COMMAND:ADDRESS:HIVALUE
"X1000"
sets the value to X1000.
SEARCH:SEARCH1:TRIGGER:A: BUS:MIL1553B:COMMAND:ADDRESS:HIVALUE?
might return "XXXXX", indicating that the value is XXXXX.
SEARCH:SEARCH<x>:TRIGger:A:BUS:MIL1553B:COMMAND:ADDRess:QUALifier
This command sets or queries the qualifier to be used when searching on command
word addresses for a MIL-STD-1553 bus. The search number is specified by x.
The search condition must be set to COMMAND.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:MIL1553B:
COMMAND:ADDRess:QUALifier
{EQual|UNEQual|LESSthan
|MOREthan|LESSEQual|MOREEQual|INrange|OUTrange}
SEARCH:SEARCH<x>:TRIGger: A:BUS:MIL1553B:COMMAND:ADDRess:
QUALifier?
Arguments
Arguments are the available address qualifiers.
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:MIL1553B:COMMAND:ADDRESS:QUALIFIER
LESSTHAN
sets the address qualifier to less than.
SEARCH:SEARCH1:TRIGGER:A: BUS:MIL1553B:COMMAND:ADDRESS:QUALIFIER?
might return EQUAL, indicating that the address qualifier is set to equal.
SEARCH:SEARCH<x>:TRIGger:A:BUS:MIL1553B:COMMAND:ADDRess:VALue
This command sets or queries the low value when searching on command word
addresses for a MIL-STD-1553 bus. The search number is specified by x. The
search condition must be set to COMMAND.
2-682 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English