Commands listed in alphabetical order
MATH:MATH<x>
:SPECTral:TYPE
This command sets or queries the FFT type selected for spectral analysis. The
math waveform is specified by x.
Group
Math
Syntax
MATH:MATH<x>:SPECTral:TYP E {MAGNitude|PHASe|REAL|IMAG inary}
MATH:MATH<x>:SPECTral:TYP E?
Arguments
MAGNitude specifies the magnitude spectral function.
PHASe specifies the phase spectral function.
REAL speci fies the real spectral function.
IMAGinary specifies the imaginary spectral function.
Examples
MATH:MATH1:SPECTral:TYPE REAL specifies the real spectral function.
MATH:MATH1:SPECTral:TYPE? might return :MATH:MATH1:SPECTRAL:TYPE
MAGNITUDE
indicating the math is the magnitude spectral function.
MATH:MATH<x>:SPECTral:UNWRap
This command sets or queries whether phase unwrap of the spectral analyzer
output data is enabled. The Math waveform is specified by x.
Group
Math
Syntax
MATH:MATH<x>:SPECTral:UNW Rap {OFF|ON|0|1}
MATH:MATH<x>:SPECTral:UNW Rap?
Arguments
0 disables phase unwrap for the specified math waveform.
1 enables phase unwrap for the specified math waveform.
ON enables phase unwrap for the specified math waveform.
OFF disables phase unwrap for the spec ified math waveform.
Examples
MATH1:SPECTRAL:UNWRAP ON enables phase unwrap of the spectral a
nalyzer
output data.
2-376 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
