Tektronix MSO56 User Manual

Commands listed in alphabetical order
Examples
SEARCH:SEARCH
1:TRIGGER:A:BUS:CAN:ERRTYPE ACKMISS
specifies
searching for any missing ACK fields.
SEARCH:SEARC
H1:TRIGGER:A:BUS:CAN:ERRTY PE?
might return
ANYERROR, indicating that the bus is being searched for all error t ypes.
SEARCH:SEARCH<x>:TRIGger:A:BUS:CAN:FD:BRSBit
This command sets o r queries the value of the bit rate switch bit (BRS bit) for a
CAN bus to search on. The search number is specified by x. The search condition
must be set to FDBITS, and the CAN standard must be FDISO or FDNONISO.
Conditions
Requires the S
R-AERO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:FD:BRSBit {ONE|ZERo|NOCARE}
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:FD:BRSBit?
Arguments
ONE filters CAN FD packets to only match those where the BRS bit has a value of
1 (fast data enabled).
ZERo filters CAN FD packets to only match those where the BRS bit has a value
of 0 (fast data disabled).
NOCARE disables fi ltering of CAN FD packets on the BRS bit.
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:CAN:FD:BRSBit ONE specifies filtering
CAN FD packets for those where the BRS bit has a value of 1.
SEARCH:SEARCH1:TRIGGER:A: BUS:CAN:FD:BRSBIT? might return
NOCARE, indicating that CAN FD packets are not being filtered based on the
BRS bit value.
SEARCH:SEARCH<x>:TRIGger:A:BUS:CAN:FD:ESIBit
This command sets or queries the value of the error state indicator bit (ESI bit)
for a CAN bus to search on. The search number is specified by x. The search
condition must be set to FDBITS, and the CAN standard must be FDISO or
FDNONISO.
Conditions
Requires the SR-AERO Triggering and Anal
ysis application.
2-646 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English