Tektronix MSO56 User Manual

Commands listed in alphabetical order
Examples
SEARCH:SEARCH
2:TRIGger:A:BUS:LIN:ERRTYPE Parity
sets the error
type to parity.
SEARCH:SEARC
H2:TRIGger:A:BUS:LIN:ERRTY PE?
might return
:SEARCH:SEARCH2:TRIGGER:A: BUS:LIN:ERRTYPE SYNC, indicating that
theerrortypeissync.
SEARCH:SEA
RCH<x>:TRIGger:A:BUS:LIN:IDentifier:VALue
This command sets or queries the string used for a LIN bus identifier value. The
search number is specified by <x>. The search condition m ust be IDENTIFIER
or IDANDD
ATA .
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:LIN:IDentifier:VALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A :BUS:LIN:IDentifier:VALue?
Arguments
<QString> specifies the identifier value.
Examples
SEARCH:SEARCH1:TRIGger:A:B US:LIN:IDentifier:VALue 1 010 sets
the identifier value to XX1010.
SEARCH:SEARCH1:TRIGger:A:B US:LIN:IDentifier:VALue? might return
:SEARCH:SEARCH1:TRIGGER:A: BUS:LIN:IDENTIFIER:VALUE "XXXXXX",
indicates the identifier value is don’t care.
SEARCH:SEARCH<x>:TRIGger:A:BUS:MIL1553B:COMMAND:ADDRess:HIVALue
This command sets or queries the high value when searching on command word
addresses for a MIL-STD-1553 bus. The search number is specified by x. The
search condition must b e set to COMMAND, and the address qualifier must be
INrange or OUTrange.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Search and Mark
MSO54, MSO56, MSO58, MSO58LP Programmer 2-681

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English