Commands listed in alphabetical order
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:MIL 1553B:STATus:ADDRess:HIVALue
<QString>
TRIGger:{A|B}:BUS:B<x>:MIL 1553B:STATus:ADDRess:HIVALue?
Arguments
<QString> is the address value.
Examples
TRIGGER:A:BUS:B1:MIL1553B: STATUS:ADDRESS:HIVALUE "X 1000" sets
the value to X1000.
TRIGGER:A:BUS:B1:MIL1553B: STATUS:ADDRESS:HIVALUE? might return
"XXXXX", indicating that the value is XXXXX.
TRIGger:{A|B}:BUS:B<x>:MIL1553B:STATus:ADDRess:QUALifier
This command s ets o r queries the qualifier to be used when triggering on status
word addresses for a MIL-STD-1553 bus. The bus number is specified by x. The
trigger condition must be set to STATus.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:MIL 1553B:STATus:
ADDRess:QUALifier
{EQual|UNEQual|LESSthan
|MOREthan|LESSEQual|MOREEQual|INrange|OUTrange}
TRIGger:{A|B}:BUS:B<x>:MIL 1553B:STATus:ADDRess:QUALifier?
Arguments
Arguments are the available address qualifiers.
Examples
TRIGGER:A:BUS:B1:MIL1553B: STATUS:ADDRESS:QUALIFIER LESSTHAN
sets the address qualifier to less than.
TRIGGER:A:BUS:B1:MIL1553B: STATUS:ADDRESS:QUALIFIER? might return
EQUAL, indicating that the address qualifier is set to equal.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-821
To Next Page