To Next Page

To Previous Page

Commands listed in alphabetical order

Syntax

WFMOutpre:XUN

it?

Related Commands

DATa:SOUrce

Examples

WFMOUTPRE:XUNIT? might return :WFMOUTPRE:XUNIT "HZ", indicating that

the horizontal units for the waveform are in Hertz.

WFMOutpre:XZEro? (Query Only)

This query-only command returns the sub-sample time between the trigger

sample (designated by PT_OFF) and the occurrence of the actual trigger for

the waveform speciﬁed by the DATa:SOUrce command. This value is in units

of WFMOutpre:XUNit.

An er

ror is reported if the DATa:SOUrce waveform does not exist.

NOTE. During steady state operation, when all control changes have settled and

triggers are arriving on a regular basis, this is the only part of the preamble that

changes on each acquisition.

Group

Waveform Transfer

Syntax

WFMOutpre:XZEro?

Related Commands

DATa:SOUrce, WFMOutpre:XUNit?

Examples

WFMOUTPRE:XZERO? might return :WFMOUTPRE:XZERO 5.6300E-9, indicating

that the trigger actually occurred 5.63 ns before the trigger sample.

WFMOutpre:YMUlt? (Query Only)

This query-only command returns the vertical scale factor per digitizing level

in units speciﬁed by WFMOutpre:YUNit for the waveform speciﬁed by the

DATa:SOUrce command. For those formats in which WFMOutpre:BYT_Nr is

important(allnon-ﬂoating point formats), WFMOutpre:YMUlt? must take the

location of the binary point implied by BYT_NR into consideration.

An error is reported if the DATa:SOUrce waveform does not exist.

Group

Waveform Transfer

2-898 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO56 User Manual

Questions and Answers: