To Next Page

To Previous Page

Commands listed in alphabetical order

For Positive Du

ty Cycle measurement, the parameters is “PDUTY”.

For Negative Duty Cycle measurement, the parameters is “NDUTY”.

For Positive Pulse Width measurement, the parameters is “PPULSE”.

For Negative Pulse Width measurement, the p arameters is “NPULSE”.

For Cycle Amplitude measurement, the parameters is “AMPL”.

For Cycle Peak–Peak measurement, the parameters is “PKPK”.

For Cycle Top measurement, the parameters is “HIGH”.

For Cycle Base measurement, the parameters is “LOW”.

For Cycle Max measurement, the parameters is “MAX”.

For Cycle Min measurement , the parameters is “MIN”.

Examples

POWer:POWer1:RESUlts:CURRe ntacq:MINimum? "TruePwr" might

return 5.1307829019093E–9, indicating the minimum value of true power for all

acquisi

tions.

POWer:POWer<x>:RESUlts:ALLAcqs:PK2PK? (Query Only)

This command queries the peak-to-peak value of all acquisitions for the

measurement parameter in the speciﬁed power measurement badge. The pow

measurement badge is speciﬁed by x.

Conditions

Requires option 5-PWR, SUP5-PWR, or 5-PS2.

Group

Power

Syntax

POWer:POWer<x>:RESUlts:ALL Acqs:PK2PK? <QString>

Arguments

<QString> = parameters of the mea surements. The details of the parameters for

the Power measurements are listed below:

For Power Quality measurement, the parameters are "TRUEPWR" | "APPPWR"

"VCFACTOR" | "IRMS" | "VRMS".

For Switching Loss measurement, the parameters are "TONENRG" | "TONLOSS"

"TTLENRG".

For dV by dt m easurement, the parameter is “DVBYDT”.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-565

Tektronix MSO56 User Manual

Questions and Answers: