Tektronix MSO56 User Manual

Commands listed in alphabetical order
Arguments
ON specifies to u
se logic qualification.
OFF specifies not to use logic qualification.
Examples
SEARCH:SEARCH1:TRIGger:A: PULSEWidth:LOGICQUALification ON
turns on logic qualification.
SEARCH:SEARCH1:TRIGger:A: PULSEWidth:LOGICQUALification? might
return
:SEARCH:SEARCH1:TRIGGER:A: PULSEWIDTH:LOGICQUALIFICATION
OFF
indicating logic qualification is off.
SEARCH:SEARCH<x>:TRIGger:A:PULSEWidth:LOWLimit
This command specifies the lower limit to use, in seconds, when searching for
a pulse whose duration is inside or outside a range of two values. The search
number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:PULSEWidth:LOWLimit <NR 3>
SEARCH:SEARCH<x>:TRIGger: A:PULSEWidth:LOWLimit?
Arguments
<NR3> is the lower limit to use, in seconds, when searching f or a pulse.
Examples
SEARCH:SEARCH1:TRIGger:A: PULSEWidth:LOWLimit 0.5e- 9 sets the
low limit to 0.5 ns.
SEARCH:SEARCH1:TRIGger:A: PULSEWidth:LOWLimit? might return
:SEARCH:SEARCH1:TRIGGER:A :PULSEWIDTH:LOWLIMIT 1.00 00E-9
indicating the low limit is 2.0 ns.
SEARCH:SEARCH<x>:TRIGger:A:PULSEWidth:POLarity
This command specifies the polarity for a pulse width search. The search number
is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:PULSEWidth:POLarity
{POSitive|NEGative}
SEARCH:SEARCH<x>:TRIGger: A:PULSEWidth:POLarity?
2-724 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English