Tektronix MSO56 - SEARCH:SEARCH<x>:TRIGger:A:EDGE:SOUrce

Commands listed in alphabetical order
Arguments
RISe specifies a
rising edge.
FALL specifies a falling edge.
EITher specifi es either rising or falling edge.
Examples
SEARCH:SEARCH1:TRIGGER:A: EDGE:SLOPE RISE sets the slope for search
1torise.
SEARCH:SEARCH1:TRIGGER:A: EDGE:SLOPE? might return
:SEARCH:SEARCH1:TRIGGER:A :EDGE:SLOPE RISE, indicating that the slope
for the trigger for search 1 is rise.
SEARCH:SEARCH<x>:TRIGger:A:EDGE:SOUrce
This command sets or queries the source waveform for an edge trigger search to
determine where to place a mark. The search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:EDGE:SOUrce
{CH<x>|CH<x>_D<x>|MATH<x> |REF<x>|REF<x>_D<x>}
SEARCH:SEARCH<x>:TRIGger: A:EDGE:SOUrce?
Arguments
CH<x> specifies one input channel as the edge source, where the channel number
is specified by <x>.
CH<x>_D<x> specifies a digital reference waveform as the source waveform
for the specified search.
MATH<x> specifies the math waveform as the search source, where the math
number is specified by <x>.
REF<x> spec ifies the reference waveform as the search source, where the
reference number is specified by <x>.
REF<x>_D<x> specifies a digital referenc e waveform as the source waveform
for the specified search.
Examples
SEARCH:SEARCH1:TRIGGER:A: EDGE:SOURCE CH2 sets the source waveform
for the A trigger to Channel 2.
SEARCH:SEARCH1:TRIGGER:A: EDGE:SOURCE? might return
:SEARCH:SEARCH1:TRIGGER:A :EDGE:SOURCE CH2, indicating that the
Channel 2 edge trigger is the source for search 1.
2-714 MSO54, MSO56, MSO58, MSO58LP Programmer