Commands listed in alphabetical order
Examples
DISplay:PLOTV
iew1:CURSor:DDT?
might return
:DISPLAY:PLOTVIEW1:CURSOR :DDT 131.0470E+6 indicating the cursor
readout value is 131.0470E+6.
DISplay:PLO
TView<x>:CURSor:FUNCtion
This command sets or queries the cursor mode of the specified cursor in the
specified view.
Group
Cur
sor
Syntax
DISplay:PLOTView<x>:CURSo r:FUNCtion
{WAVEFORM|VBArs|HBArs|SCR EEN}
DISplay:PLOTView<x>:CURSo r:FUNCtion?
Arguments
WAVEFORM specifies to display the paired cursors in YT display format for
measuring waveform amplitude and time.
VBArs specifies vertical bar cursors, which measure in horizontal units.
HBArs specifies horizontal bar cursors, which measure in vertical units.
SCREEN specifies to display both horizontal and vertical ba r cursors, which
measure the selected waveform in horizontal and vertical units. Use these cursors
to measure a nywhere in the waveform display area.
Examples
DISplay:PLOTView1:CURSor: FUNCtion VBARS displays vertical bar cursors.
DISplay:PLOTView1:CURSor: FUNCtion? might return
:DISPLAY:PLOTVIEW1:CURSOR :FUNCTION SCREEN indicating that
both horizontal and vertical bar cursors are displayed.
DISplay:PLOTView<x>:CURSor:HBArs:APOSition
This command sets or queries the vertical cursor A position of the specified cursor
in the specified view.
Group
Cursor
Syntax
DISplay:PLOTView<x>:CURSo r:HBArs:APOSition <NR3>
DISplay:PLOTView<x>:CURSo r:HBArs:APOSition?
2-250 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
