Commands listed in alphabetical order
SEARCH:SEARC
H<x>:TRIGger:A:BUS:AUDio:CONDition
This command sets or queries the condition (word select / frame sync, or matching
data) to be used when searching on an audio bus signal. The search number is
specified by <
x>.
Conditions
Requires the SR-AUDIO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:AUDio:CONDition {SOF |DATa}
SEARCH:SEARCH<x>:TRIGger:A :BUS:AUDio:CONDition?
Arguments
SOF specifies to search on a word select or start of frame (depending on Audio
Type).
DATA specifies to search on matching data.
Examples
SEARCH:SEARCH1:TRIGger:A:B US:AUDio:CONDition SOF sets conditions
to search on s tart of frame.
SEARCH:SEARCH1:TRIGger:A:B US:AUDio:CONDition? might return
:SEARCH:SEARCH1:TRIGGER:A: BUS:AUDIO:CONDITION DATA indicating
settings for a search on DATA.
SEARCH:SEARCH<x>:TRIGger:A:BUS:AUDio:DATa:HITDMVALue
This command sets or queries the binary data string for the high data word to be
used when searching on a n TDM audio bus signal. The search condition must be
set to DATa using
SEARCH:SEARCH{x}:TRIGger:A: BUS:AUDio:CONDition.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:AUDio:DATa:HITDMVALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A :BUS:AUDio:DATa:HITDMVALue?
Arguments
<QString> is the binary data string for the high data word to be used when
searching on an TDM audio bus signal.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-637
To Next Page
Loading...
Need help?
General
