Commands listed in alphabetical order
MEASUrement:M
ATH<x>:REFLevels:PERCent:TYP E?
Arguments
TENNinety sets the values for Low, Mid and High Ref to 10%, 50% and 90%
respectively.
TWENtyeighty sets the values for Low, Mid and High Ref are set to 20%, 50%
and 80% respectively.
CUSTom allows setting other reference level percents.
Examples
MEASUrement:MATH2:REFLeve ls:PERCent:TYPE TWENTYEIGHTY sets the
values for Low, Mid and High Ref are set to 20%, 50% and 80% respectively.
MEASUrement:MATH2:REFLeve ls:PERCent:TYPE? might return
:MEASUREMENT:MATH2:REFLEV ELS:PERCENT:TYPE TENNINETY indicating
the reference levels are set to 10%, 50% and 90%.
MEASUrement:MEASRange:MAX
This command sets or queries the global range maximum value.
Group
Measurement
Syntax
MEASUrement:MEASRange:MAX <NR3>
MEASUrement:MEASRange:MAX ?
Arguments
<NR3> is the maximum measurement range limit value.
Examples
MEASUREMENT:MEASRANGE:MAX 1.5 sets the maximum range limit to 1.5 V.
MEASUREMENT:MEASRANGE:MAX? might return
:MEASUREMENT:MEASRANGE:MA X 1.0000 indicating the m aximum range
limit is 1.0 V.
MEASUrement:MEASRange:MIN
This command sets or queries the global range minimum value.
Group
Measurement
Syntax
MEASUrement:MEASRange:MIN <NR3>
MEASUrement:MEASRange:MIN ?
2-420 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
