Commands listed in alphabetical order
Syntax
BUS:B<x>:LABe
l:XPOS <NR 3>
BUS:B<x>:LABel:XPOS?
Arguments
<NR3> is the x-position, in pixels relative to the left edge of the screen,, of the
specified bus label.
Examples
BUS:B1:LABel:XPOS 90 set the x position to 90.
BUS:B1:LABel:XPOS? might return :BUS:B1:LABEL:XPOS 45.0000
indicating the x position is 45.0 pixels to the right of the left edge of the display.
BUS:B<x>:LABel:YPOS
This command sets or q ueries the y -position o f the specified bus label. The bus
is specified by x.
Group
Bus
Syntax
BUS:B<x>:LABel:YPOS <NR3>
BUS:B<x>:LABel:YPOS?
Arguments
<NR3> is the y-position, in pixels relative to the baseline of the waveform, of
the specified bus label.
Examples
BUS:B1:LABel:YPOS 1.0e1 set the y position to 10.0.
BUS:B1:LABel:YPOS? might return :BUS:B1:LABEL:YPOS 0.0E+0
indicating the y position is 0.0 pixels from the baseline of the waveform.
BUS:B<x>:LIN:BITRate
This command sets or queries the LIN bus bit rate. The bus number is specified by
x. If you select Custom, use BUS:B<x>:LIN:BITRate:CUSTom to set the bit rate.
Conditions
Requires option SR-AUTO.
Group
Bus
Syntax
BUS:B<x>:LIN:BITRate
{RATE10K|RATE1K|RATE19K|RA TE2K|RATE4K|RATE9K|CUSTom}
MSO54, MSO56, MSO58, MSO58LP Programmer 2-151
To Next Page
Loading...
Need help?
General
