Tektronix MSO56

Commands listed in alphabetical order
Arguments
<NR3> is the min
imum measurement range limit value.
Examples
MEASUREMENT:MEASRANGE:MIN 30.0E-3 sets the minimum measurement range
limit to 30.0 mV.
MEASUREMENT:MEASRANGE:MIN? might return
:MEASUREMENT:MEASRANGE:MIN 0.0E+0 indicating minimum range limit is
0.0 V.
MEASUrement:MEASRange:STATE
This command sets or q ueries the global range state.
Group
Measurement
Syntax
MEASUrement:MEASRange:STAT E {OFF|ON|0|1}
MEASUrement:MEASRange:STAT E?
Arguments
OFF specifies that the measurement results are not limited.
ON specifies that the measurement results are limited to results with values
between the range minimum and maximum.
0 specifies that the measurement results are not limited.
1 specifies that the measurement results are limited to results with values between
the range minimum and maximum.
Examples
MEASUREMENT:MEASRANGE:STAT E 1 specifies that the measurement results are
limited to results with values between the range minimum and maximum.
MEASUREMENT:MEASRANGE:STAT E? might return
:MEASUREMENT:MEASRANGE:STA TE 0 indicating that the measurement results
are not limited.
MEASUrement:MEAS<x>:BER
This command sets or queries BER value for the measurement. Measurements
are specified by x.
Group
Measurement
MSO54, MSO56, MSO58, MSO58LP Programmer 2-421