Tektronix MSO56 - MEASUrement:MEAS<x>:POLarity; MEASUrement:MEAS<x>:POPUlation:GLOBal

Commands listed in alphabetical order
MEASUrement:
MEAS<x>:POLarity
This command sets or queries the polarity for the measurement when the
measurement type is burst width. Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:POLari ty {NORMal|INVerted}
MEASUrement:MEAS<x>:POLari ty?
Arguments
NORMal specifies normal polarity.
INVerted specifies inverted polarity.
Examples
MEASUrement:MEAS1:POLarity INVERTED specifies inverted polarity.
MEASUrement:MEAS1:POLarity ? mig
ht return
:MEASUREMENT:MEAS1:POLARIT Y NORMAL indicating normal polarity.
MEASUrement:MEAS<x>:POPUlation:GLOBal
This command sets or queries the population settings global flag. The
measurement number is specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:POPUla tion:GLOBal {OFF|ON|0|1}
MEASUrement:MEAS<x>:POPUla tion:GLOBal?
Arguments
OFF specifies that population settings can be changed independently for each
individual measurement.
ON applies the global population settings to all the measurements' population
settings.
0 specifies that population settings can be changed independently for each
individual measurement.
1 applies the global population settings to all the measurements' population
settings.
Examples
MEASUrement:MEAS1:POPUlati on:GLOBal 1 applies the global population
settings to all the measurements' population settings.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-467