Commands listed in alphabetical order
Examples
BUS:B1:ARINC4
29A:SOURCE CH1
sets channel 1 as the source for the
ARINC429 bus.
BUS:B1:ARINC
429A:SOURCE?
might return :BUS:B1:ARINC429A:SOURCE
MATH2
indicating that the source is set to MATH2.
BUS:B<x>:ARINC429A:THRESHold
This command sets or queries the ARINC429 upper threshold for the specified
bus. The bus is specified by x.
Conditions
Requires option SR-AERO.
Group
Bus
Syntax
BUS:B<x>:ARINC429A:THRESHo ld <NR3>
BUS:B<x>:ARINC429A:THRESHo ld?
Related Commands
BUS:B<x>:ARINC429A:SOUrce
Arguments
<NR3> is the ARINC429 lower threshold for the specified bus.
Examples
BUS:B3:ARINC429A:THRESHOLD -200e-3 sets the Bus 3 ARINC429 upper
threshold to -200 mV.
BUS:B2:ARINC429A:THRESHOLD ? might return
:BUS:B2:ARINC429A:THRESHOL D -500.0000E-3 indicating the Bus 2
ARINC429 upper threshold is
setto-500mV.
BUS:B<x>:AUDio:BITDelay
This command sets or queries the number of delay bits for the specified AUDIO
bus. The bus is specified by x.
NOTE. This command only applies to the TDM Audio type.
Conditions
Requires option SR-AUDIO.
Group
Bus
MSO54, MSO56, MSO58, MSO58LP Programmer 2-117
To Next Page
Loading...
Need help?
General
