Commands listed in alphabetical order
TRIGger:A:HO
LDoff:TIMe
This command sets or queries the A trigger holdoff time. This command is
equivalent to selecting Mode & Holdoff from the Trig menu, selecting Time, and
then setting
the desired Holdoff Time.
Group
Trigger
Syntax
TRIGger:A:HOLDoff:TIMe <NR3>
TRIGger:A:HOLDoff:TIMe?
Related Commands
TRIGger:A:HOLDoff:BY
Arguments
<NR3> specifies the holdoff time in seconds. The range is from 0 seconds through
10 seconds.
Examples
TRIGGER:A:HOLDOFF:TIME 10 sets the A trigger holdoff time to 10 s.
TRIGGER:A:HOLDOFF:TIME? might return :T RIGGER:A:HOLDOFFTIME
1.2000E-06
, indicating that the A trigger holdoff time is set to 1.2 µs.
TRIGger:A:LOGICQUALification
This command sets or queries the type of logic qualification to perform.
Group
Trigger
Syntax
TRIGger:A:LOGICQUALificat ion {AND|OR|NAND|NOR}
TRIGger:A:LOGICQUALificat ion?
Arguments
AND specifies to trigger if a ll conditions are true.
NANd specifies to trigger if any of the c onditions are false.
NOR specifies to trigger if all conditions are false.
OR specifies to trigger if any of the conditions are true.
Examples
TRIGGER:A:LOGICQUALIFICAT ION OR specifies to trigger if any of the
conditions a
re true.
2-876 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
