Tektronix MSO56 - SEARCH:SEARCH<x>:TRIGger:A:BUS:FLEXRAY:CYCLEcount:VALue

Commands listed in alphabetical order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:BUS:FLEXRAY:CY CLEcount:QUALifier
{EQUal|LESSEQual|MOREEQua l|UNEQual|LESSthan|MOREthan|
INrange|OUTrange}
SEARCH:SEARC
H<x>:TRIGger:A:BUS:FLEXRAY :CYCLEcount:QUALifier?
Arguments
Arguments are the available cycle count qualifiers.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:FLEXRAY:CYCLEcount:QUALifier
LESSthan
sets the cycle count qualifier to less than.
SEARCH:SEARCH1:TRIGger:A: BUS:FLEXRAY:CYCLEcount:QUALifier?
might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:FLEXRAY:CYCLECOUNT:QUALIFIER
EQUAL
, indicating the cycle count qualifier is set to equal.
SEARCH:SEARCH<x>:TRIGger:A:BUS:FLEXRAY:CYCLEcount:VALue
This command s ets or queries the low value when searching on a FlexRay bus
cycle count field. The search number is specified by <x>. The search condition
must be set to CYCLEcount.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:FLEXRAY:CYCLEcount:VALue
<QString>
SEARCH:SEARCH<x>:TRIGger: A:BUS:FLEXRAY:CYCLEcount:VALue?
Arguments
<QString> specifies the cycle count value.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:FLEXRAY:CYCLEcount:VALue "1010"
sets the cycle count value to XX1010.
SEARCH:SEARCH1:TRIGger:A: BUS:FLEXRAY:CYCLEcount:VALue? might
return
:SEARCH:SEARCH1:TRIGGER:A:BU S:FLEXRAY:CYCLECOUNT:VALUE
"XXXXXX"
, indicating the cycle count value is don’t care, and it will trigger on
any cycle count.
2-664 MSO54, MSO56, MSO58, MSO58LP Programmer