Commands listed in alphabetical order
NOTE. Do not use
DHCP searching if your oscilloscope has been assigned a
static address on a network. If you set this command to ON, the DHCP search will
delete or change your static IP address information.
OFF disables the oscilloscope to search the network for a DHCP server.
Examples
ETHERNET:DHCPBOOTP ON sets the oscilloscope to search for a DHCP server and
assign a dynamic IP address to the oscilloscope.
ETHERnet:DNS:IPADDress
This command spec ifies the network Domain Name Server (DNS) IP address.
Group
Ethernet
Syntax
ETHERnet:DNS:IPADDress <QString>
ETHERnet:DNS:IPADDress?
Arguments
<QString> is a standard IP address value, enclosed in quotes.
Examples
ETHERNET:DNS:IPADDRESS "128.196.13.252" sets the DNS IP address that
the oscilloscope uses to communicate with the network.
ETHERnet:DOMAINname
This command specifies the n etwork domain name.
Group
Ethernet
Syntax
ETHERnet:DOMAINname <QString>
ETHERnet:DOMAINname?
Arguments
<QString> is the network domain name, enclosed in quotes.
Examples
ETHERNET:DOMAINNAME "Alpha1.Mycorp.com" sets the domain name that
the oscilloscope uses to communicate with the network.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-323
To Next Page
Loading...
Need help?
General
