Tektronix MSO56 User Manual

Commands listed in alphabetical order
indicating tha
t hexadecimal XX22 has been set as the value to use when searching
on the Ethernet TCP header destination port number.
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:TCPHeader:SEQnum:VALue
This command spec ifies the binary sequence number value to use when searching
on an Ethernet bus signal. The default is all X’s (don’t care). The search condition
needstobesetto
TCPHeader. The search number is specified by <x>.
Conditions
Requires the SR-ENET Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:ETHERnet:TCPHeader:SEQnum:
VALue < QString>
SEARCH:SEARCH<x>:TRIGger:A :BUS:ETHERnet:TCPHeader:SEQnum:
VALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:CONDition
Arguments
QString is a quoted string of up to 32 characters where the allowable characters
are0,1,andX.Thebitsspecified in the quoted string replace the least significant
b
its, leaving any unspecified upper bits unchanged.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:ETHERNET:TCPHEADER:SEQNUM:VALUE
"XXXXXXXXXXXXXXXXXXXX00010 0010001"
specifies to use the value of
hexadecimal XXXXX111 when searching on the Ethernet TCP header sequence
number.
SEARCH:SEARCH1:TRIGGER:A:B US:ETHERNET:TCPHEADER:SEQNUM:VALUE?
might return "XXXXXXXXXXXXXXXXXXXXXX0010010100" , indicating
that hexadecimal XXXXX111 has been specified as the value to use when
searching on the Ethernet TCP header sequence number. .
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:TCPHeader:SOUrceport:VALue
This command specifies the binary source port value to use when searching on
an Ethernet bus signal. The search condition needs to be set to
TCPHeader.The
search number is specified by <x>.
Conditions
Requires the SR-ENET Triggering and Analysis application.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-661

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English