Commands listed in alphabetical order
BUS:B<x>:TYP
e
This command sets or queries the bus type or sta ndard for the specified bus. The
bus is specified by x.
Group
Bus
Syntax
BUS:B<x>:TY
Pe {PARa llel|CAN|SPI|FLE XRAY|LIN|I2C|
USB|RS232C|ETHernet|AUDio}
BUS:B<x>:TYPe?
Arguments
PARallel specifies a parallel bus.
I2C specifies the Inter-IC bus.
SPI specifies the Serial Peripheral Interface bus.
RS232C specifies the RS-232 Serial bus.
CAN specifies a Controller Area Network bus.
LIN specifies a Local Interconnect Network bus.
FLEXRAY specifies a FlexRay bus.
USB specifies the Universal Serial Bus.
ETHernet specifies the Ethernet bus.
AUDio specifies an audio bus.
Examples
BUS:B1:TYPE I2C sets the bus B1 type to I2C.
BUS:B1:TYPE? might return :BUS:B1:TYPE SP I, indicating that the
bus B1 type is set to SPI and that the bus behavior is governed by the
:BUS:B1:SPI:xxxx commands.
BUS:B<x>:USB:BITRate
This command sets or queries the U SB data rate for bus <x>, where the bus
number is specified by <x>.
Conditions
Requires option SR-USB2.
Group
Bus
MSO54, MSO56, MSO58, MSO58LP Programmer 2-177
To Next Page