Tektronix MSO56 User Manual

Commands listed in alphabetical order
Conditions
Requires the SR
-ENET Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:ETH ERnet:TCPHeader:DESTinationport:
VALue < QString>
TRIGger:{A|B}:BUS:B<x>:ETH ERnet:TCPHeader:DESTinationport:
VALue?
Related Commands
TRIGger:{A|B}:BUS:B<x>:ETHERnet:CONDition
TRIGger:{A|B}:BUS:B<x>:ETHERnet:TCPHeader:ACKnum:VALue
TRIGger:{A|B}:BUS:B<x>:ETHERnet:TCPHeader:SOUrceport:VALue
TRIGger:{A|B}:BUS:B<x>:ETHERnet:TCPHeader:SEQnum:VALue
Arguments
<QString> is a quoted string of up to 16 characters where the allowable
characters are 0, 1, and X. The bits specified in the quoted string replace the least
significant bits, leaving any unspecified upper bits unchanged.
Examples
TRIGger:A:BUS:B1:ETHERnet: TCPHeader:DESTinationport:VALue
"XXXXXXXX00100010"
would set the destination port address value that is to be
used in the trigger to hexadecimal
XX22.
TRIGger:A:BUS:B1:ETHERnet: TCPHeader:DESTinationport:VALue?
might return "XXXXXXXXXXXXXXXX".
TRIGger:{A|B}:BUS:B<x>:ETHERnet:TCPHeader:SEQnum:VALue
When the Ethernet trigger condition is set to TCPHeader, this command specifies
the 32–bit sequence number that is to be used in the trigger (along with the
destination and source port addresses and the acknowledgement value). The
default is all X’s (don’t care). The bus number is specified by <x>.
Conditions
Requires the SR-ENET Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:ETH ERnet:TCPHeader:SEQnum:VALue
<QString>
TRIGger:{A|B}:BUS:B<x>:ETH ERnet:TCPHeader:SEQnum:VALue?
MSO54, MSO56, MSO58, MSO58LP Programmer 2-791

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English