Tektronix MSO56

Commands listed in alphabetical order
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:CAN:FD:ESIBit {ONE|ZERo|NOCARE}
SEARCH:SEARCH<x>:TRIGger:A :BUS:CAN:FD:ESIBit?
Arguments
ONE filters CAN FD packets to only match those where the ESI bit has a value
of 1 (recessive).
ZERo filters CAN FD packets to only match those where the ESI bit has a value
of 0 (dominant).
NOCARE disables fi ltering of CAN FD packets on the ESI bit.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:CAN:FD:ESIBit ONE specifies filtering
CAN FD packets for those where the ESI bit has a value of 1.
SEARCH:SEARCH1:TRIGGER:A:B US:CAN:FD:ESIBIT? might return
NOCARE, indicating that CAN FD packets are not being filteredbasedonthe
ESI bit value.
SEARCH:SEARCH<x>:TRIGger:A:BUS:CAN:FRAMEtype
This command sets or queries CAN bus trigger frame type to be used when
searching on a CAN bus signal. The search condition must be set to FRAMEtype.
Thesearchnumberisspecified by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:CAN:FRAMEtype
{DATa|ERRor|OVERLoad|REMot e}
SEARCH:SEARCH<x>:TRIGger:A :BUS:CAN:FRAMEtype?
Arguments
Arguments are the available frame types.
Examples
SEARCH:SEARCH1:TRIGger:A:B US:CAN:FRAMEtype ERROR sets the frame
type to error.
SEARCH:SEARCH1:TRIGger:A:B US:CAN:FRAMEtype? might return
:SEARCH:SEARCH1:TRIGGER:A: BUS:CAN:FRAMETYPE DATA, indicates the
frame type is set to data.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-647