Tektronix MSO56 User Manual

Commands listed in alphabetical order
Conditions
Requires the SR
-ENET Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:ETHERnet:QTAG:VALue <QString>
SEARCH:SEARCH<x>:TRIGger:A :BUS:ETHERnet:QTAG:VALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:CONDition
Arguments
<QString> is a quoted string of up to 32 characters where the allowable
characters are 0, 1, and X. The bits specified in the quoted string replace the least
significant bits, leaving any unspecified upper bits unchanged.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:ETHERNET:QTAG:VALUE
"XXXXXXXXXXXXXXXXXXXX010010001010" specifies to use the value of
hexadecimal XXXXX48A when searching on the Ethernet Q-Tag field.
SEARCH:SEARCH1:TRIGGER:A:B US:ETHERNET:QTAG:VALUE? might return
"XXXXXXXXXXXXXXXXXXXX010010001010", indicating that hexadecimal
XXXXX48A has been set as the Ethernet Q-Tag field search value.
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:TCPHeader:ACKnum:VALue
This command specifies the binary ack number value to use when searching on
an Ethernet bus signal. The default is all X’s (don’t care). The search condition
needstobesetto
TCPHeader. The search number is specified by <x>.
Conditions
Requires the SR-ENET Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:ETHERnet:TCPHeader:ACKnum:
VALue < QString>
SEARCH:SEARCH<x>:TRIGger:A :BUS:ETHERnet:TCPHeader:ACKnum:
VALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:CONDition
MSO54, MSO56, MSO58, MSO58LP Programmer 2-659

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English