Commands listed in alphabetical order
Arguments
PARity specifie
s searching for an incorrectly calculated parity bit in any word.
SYNC specifies searching for any sync pulse that does not transition in the middle
of the pulse as
required.
DATA specifies searching for any non-contiguous data words.
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:MIL1553B:ERRTYPE DATA specifies
searching for non-contiguous data words.
SEARCH:SEARCH1:TRIGGER:A: BUS:MIL1553B:ERRTYPE? might return
PARITY, indicating that the bus is being searched for parity errors in any word.
SEARCH:SEARCH<x>:TRIGger:A:BUS:MIL1553B:STATus:ADDRess:HIVALue
This comma nd sets or queries the high value when searching on status word
addresses for a MIL-STD-1553 bus. The search number is specified by x. The
search condition must be set to STATus and the address qualifier must be INrange
or OUTrange.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:MIL1553B:STATus:ADDRess:
HIVALue
<QString>
SEARCH:SEARCH<x>:TRIGger: A:BUS:MIL1553B:STATus:ADDRess:
HIVALue?
Arguments
<QString> is the address value.
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:MIL1553B:STATUS:ADDRESS:HIVALUE
"X1000"
sets the value to X1000.
SEARCH:SEARCH1:TRIGGER:A: BUS:MIL1553B:STATUS:ADDRESS:HIVALUE?
might return "XXXXX", indicating that the value is XXXXX.
SEARCH:SEARCH<x>:TRIGger:A:BUS:MIL1553B:STATus:ADDRess:QUALifier
This command sets or queries the qualifier used when searching on status word
addresses for a MIL-STD-1553 bus. The search number is specified by x. The
search condition m ust be set to STATus.
2-688 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
