Commands listed in alphabetical order
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:AU Dio:CONDition {SOF|DATa}
TRIGger:{A|B}:BUS:B<x>:AU Dio:CONDition?
Arguments
SOF enables triggering on a word select or start of frame (depending on Audio
Type).
DATa enables triggering on matching data.
Examples
TRIGger:A:BUS:B1:AUDio:CO NDition SOF sets the condition to start of
frame.
TRIGger:A:BUS:B1:AUDio:CO NDition? might return
:TRIGGER:A:BUS:B1:AUDIO:C ONDITION DATA indicating the
condition is data.
TRIGger:{A|B}:BUS:B<x>:AUDio:DATa:HITDMVALue
This command sets or queries the binary data string for the high data word to be
used when triggering on an TDM audio bus signal. The trigger condition must be
set to DATa using
TRIGger:{A|B}:BUS:B<x>:AUD io:CONDition.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:AU Dio:DATa:HITDMVALue <QString>
TRIGger:{A|B}:BUS:B<x>:AU Dio:DATa:HITDMVALue?
Arguments
<QString> is the binary data string for the high data word to be used when
triggering on an TDM audio bus signal.
Examples
TRIGger:A:BUS:B1:AUDio:DA Ta:HITDMVALue "1100" sets the high value
to 1100.
TRIGger:A:BUS:B1:AUDio:DA Ta:HITDMVALue? might
return :TRIGGER:A:BUS:B1:AUDIO:DATA:HITDMVALUE
"XXXXXXXXXXXXXXXXXXXX1010 " indicating the high value is 1010.
2-766 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
