Commands listed in alphabetical order
TRIGger:{A|B
}:BUS:B<x>:USB:DATa:QUALifier
This command sets the qualifier to be used when triggering on a USB bus signal.
The trigger condition must be set to DATAPACKET. The bus number is s pecified
by <x>.
Conditions
Requires the SR-USB2 Serial Triggering and Analysis Application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:US B:DATa:QUALifier {EQual|UNEQ ual|
LESSthan|MOREthan|LESSEQu al|MOREEQual|INrange|OUTrange}
TRIGger:{A|B}:BUS:B<x>:US B:DATa:QUALifier?
Arguments
EQUal specifies the qualifier as Equal.
INrange specifi es the qualifier as Inside Range.
LESSEQual specifies the qualifi er as Less Than or Equal to.
MOREEQual specifies the qualifier as More Than or Equal to.
OUTrange specifies the qualifier as Out of Range.
UNEQual specifies the qualifier as Not Equal to.
LESSthan specifies the qualifier as Less Than.
MOREthan specifies the qualifier as More Than.
Examples
TRIGger:A:BUS:B1:USB:DATa :QUALifier LESSTHAN sets the qualifier to
less than.
TRIGger:A:BUS:B1:USB:DATa :QUALifier? might return
:TRIGGER:A:BUS:B1:USB:DAT A:QUALIFIER EQUAL indicating the qualifier
is set to equal.
TRIGger:{A|B}:BUS:B<x>:USB:DATa:SIZe
This command specifies the number of contiguous data bytes to trigger on. The
bus number is specified by <x>.
Conditions
Requires the SR-USB2 Serial Triggering and Analysis Application.
Group
Trigger
2-838 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
