Tektronix MSO56 - SEARCH:SEARCH<x>:TRIGger:A:BUS:MIL1553 B:DATa:PARity

Commands listed in alphabetical order
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:MIL1553B:CONDition
{SYNC|COMMAND|STATus|DATA|ERRor}
SEARCH:SEARCH<x>:TRIGger: A:BUS:MIL1553B:CONDition?
Arguments
SYNC specifies a search for the sync pulse of any word.
COMMAND specifies a s earch for a matching command word.
STATus specifies a search for a matching status word.
DATA specifiesasearchforamatchingdataword.
ERRor specifies a search for a specified error condition.
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:MIL1553B:CONDITION DA TA specifies
finding matching data word(s).
SEARCH:SEARCH1:TRIGGER:A: BUS:MIL1553B:CONDITION? might return
SYNC, indicating that the bus is being searched for sync pulses found in any word.
SEARCH:SEARCH<x>:TRIGger:A:BUS:MIL1553B:DATa:PARity
This command sets or queries the value of the command word parity bit for a
MIL-STD-1553 bus to search on. The search number is specified by x. The search
condition must be set to DATA.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:MIL1553B:DATa:PARity
{ONE|ZERo|NOCARE}
SEARCH:SEARCH<x>:TRIGger: A:BUS:MIL1553B:DATa:PARity?
Arguments
ONE filters data words to only match those where the parity bit has a value of 1.
ZERo filters data words to only match those where the parity bit has a value of 0.
NOCARE disables filtering of data words on the parity bit.
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:MIL1553B:DATA:PARITY ONE specifies
filtering data words for those where the parity bit has a value of 1.
2-686 MSO54, MSO56, MSO58, MSO58LP Programmer