Command groups
Table 2-34: Power commands (cont.)
Command Description
POWer:POWer<x>:HARMONICS:
RCURRent
Sets or queries the rated current for the harmonics measurement in the specified power
measurement badge.
POWer:POWer<x>:HARMONICS:
STANDard
Sets or queries the test mode for harmonics measurement in the speci fied power measurement
badge.
POWer:POWer<x>:HARMONICS:
UNITs
Sets or queries the harmonics results units in the specified power measurement badge.
POWer:POWer<x>:HARMONICS:
VSOURce
Sets or queries the voltage source for SOA measurement in the specified power measurement
badge.
POWer:POWer<x>:LABel Sets or queries the custom name for the specified power measurement badge.
POWer:POWer<x>:LINERIPPLE:
INPUTSOurc e
Sets or queries the input source for line ripple measurement in the specified power
measurement badge.
POWer:POWer<x>:LINERIPPLE:
LFREQuency
sSets or queries the frequency present for line ripple measurement in the s pecified power
measurement badge.
POWer:POWer<x>:
NDUTYCYCLE:EDGEType
Sets or queries the clock edge type for negative duty cycle measurement in the specified
power measurement badge.
POWer:POWer<x>:
NDUTYCYCLE:INPUTSOurce
Sets or queries the input source for negative duty cycle measurement in the specified power
measurement badge.
POWer:POWer<x>:
NPULSEWIDTH:INPUTSOurce
Sets or queries the input source for negative pulse width measurement in the specified power
measurement badge.
POWer:POWer<x>:
PDUTYCYCLE:EDGEType
Sets or queries the clock edge type for positive duty cycle measurement in the specified
power measurement badge.
POWer:POWer<x>:
PDUTYCYCLE:INPUTSOurce
Sets or queries the input source for positive duty cycle measurement in the specified power
measurement badge.
POWer:POWer<x>:PERIOD:
EDGe
Sets or queries the edge type for period m easurement in the specified power measurement
badge.
POWer:POWer<x>:PERIOD:
INPUTSOurc e
Sets or queries the input source for period measurement in the specified power measurement
badge.
POWer:POWer<x>:
POWERQUALITY:CCYCles
Sets or queries the calculate cycles over full cycles settings for the specified power quality
measurement badge.
POWer:POWer<x>:
POWERQUALITY:FREFerence
Sets or queries the frequency reference type for power quality measurement in the specified
power measurement badge.
POWer:POWer<x>:
POWERQUALITY:ISOURce
Sets or queries the current source for power quality measurement in the specified power
measurement badge.
POWer:POWer<x>:
POWERQUALITY:VSOURce
Sets or queries the voltage source for power quality measurement in the specified power
measurement badge.
POWer:POWer<x>:
PPULSEWIDTH:INPUTSOurce
Sets or queries the input source for positive pulse width measurement in the s pecified power
measurement badge.
POWer:POWer<x>:REFLevels:
ABSolute:FALLHigh
Sets or queries the falling edge for high reference level in absolute units for the specified
power measurement badge.
POWer:POWer<x>:REFLevels:
ABSolute:FALLLow
Sets or queries the falling edge for low reference level in absolute units for the specified power
measurement badge.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-57
To Next Page