Status and Events
Table 3-8: System Event Messages (cont.)
Code Message
405 Request control
410
Query INTERRUPTED (QYE bit 2 set)
420
Query UNTERMINATED (QYE bit 2 set)
430
Query DEADLOCKED (QYE bit 2 set)
440
Query UNTERMINATED after indefinite response (QYE bit 2 set)
468
Knob/Keypad value changed
472 Application variable changed
Execution Warning
The following table lists warning messages that do not interrupt the flow of
command execution. They also notify you of possible unexpected results.
Table 3-9: Execution Warning Messages (EXE Bit 4)
Code Message
528
Parameter out of range
532
Curve data too long, Curve truncated
533
Curve error, Preamble values are inconsistent
540 Measurement warning, Uncertain edge
541 Measurement warning, Low signal amplitude
542 Measurement warning, Unstable histogram
543 Measurement warning, Low resolution
544 Measurement warning, Uncertain edge
545 Measurement warning, Invalid in minmax
546 Measurement warning, Need 3 edges
547
Measurement warning, Clipping positive/negative
548
Measurement warning, Clipping positive
549
Measurement warning, Clipping negative
Table 3-10: Execution Warning Messages (EXE Bit 4)
Code Message
540 Measurement warning
541 Measurement warning, Low signal amplitude
542 Measurement warning, Unstable histogram
543 Measurement warning, Low resolution
544 Measurement warning, Uncertain edge
545 Measurement warning, Invalid min max
546 Measurement warning, Need 3 edges
3-18 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
