Maintenance
5552−2/A1
RT-flex50-D
Wärtsilä Switzerland Ltd
7/ 11
5.1 Final assembly
Determine radial and axial clearances, see Clearance Table 0330−1 ’Supply Unit’.
⇒ Apply sealing compound to sealing surfaces of covers 3, 4, 5 and fit the latter.
⇒ Fit servo oil pump 2 (see 5552−1).
⇒ Install all pipings.
⇒ Cut in the fuel pumps and remove tools 94430 (see 5556−2 in the Operating
Manual).
After assembly, turn the engine by means of turning gear and check if lubricating oil
is supplied to all lubricating points and bearings with the oil pump in operation!
2010
upply Unit: Removal and Fitting of Camshaft and Bearing Shells
CHECK
CHECK
To Next Page
Loading...
