Maintenance9223−1/A1 RT-flex50-D
Wärtsilä Switzerland Ltd
6/ 22
3.4 Final works
⇒ Fit angle holder 12 using screws 11 with their locking plates. Subsequently
install protection plates 10 in such a way that they contact each other at the
centre without overlapping and touching any moveable parts, using screws 3
with their locking plates.
⇒ Tighten and lock screws 3 and 11.
⇒ After assembling fit carefully the sensor cables ’SK’. Pay attention to the clear-
ance which must exist between sensor cables and housing (Fig. ’B’, section
II).
Fit protection hood 1 together with covering cap 2.
3.5 Toothed belt change
If there should be changed only one toothed belt, proceed as follows:
⇒ Remove protection plate 10 and angle holder 12 (Fig. ’B’).
⇒ Remove screws 15a with locking plates and washers.
⇒ Remove screws 15, replace locking plates and loosely refit the screws.
⇒ Push shaft encoder inwards and replace toothed belt.
D For fitting pay attention to paragraphs 3.1 to 3.4.
3.6 Rechecking of toothed belt tension
In accordance with Maintenance Schedule 0380−1 ’Crank angle sensor unit’ the
toothed belt tension must be visually rechecked as shown in Fig. ’G’ and ’H’, and by
lightly tapping on the toothed belt with a finger.
If necessary or in case of doubt the toothed belt must be retensioned as described
in paragraph 3.2!
Attention! After every loosening of a shaft encoder the toothed belt tension must
be rechecked after about five operating hours!
2011
rank Angle Sensor Unit: Dismantling, Assembling and Adjusting
To Next Page
Loading...
Need help?
General
