YASKAWA Sigma-7 SGD7S Series - Page 715

n.X
/EXT1 (Probe 1 Latch Input) Signal Allocation
A The signal is always inactive.
B The signal is always inactive.
C The signal is always inactive.
D Active when CN1-10 input signal is OFF (open).
E Active when CN1-11 input signal is OFF (open).
F Active when CN1-12 input signal is OFF (open).
n.X
/EXT2 (Probe 2 Latch Input) Signal Allocation
0 to
F
The allocations are the same as the /EXT1 (Probe 1 Latch Input)
signal allocations.
n.X
Reserved parameter (Do not change.)
*4
8 Reserved parameter (Do not change.)
(Automatically set by the PROFINET Module.)
Param-
eter No.
Size Name Setting
Range
Setting
Unit
Default
Setting
Appli-
cable
Motors
When
Enabled
Classifi-
cation
Refer-
ence
Pn512 2 Output Signal
Inverse Set-
tings 1
0000h to
1111h
– 0000h All After
restart
Setup
Ä Chap.
7.2.3
‘Output
Signal
Alloca-
tions’
page 198
n.X
Output Signal Inversion for CN1-1 and CN1-2 Terminals
0 The signal is not inverted.
1 The signal is inverted.
n.X
Output Signal Inversion for CN1-23 and CN1-24 Terminals
0 The signal is not inverted.
1 The signal is inverted.
n.X
Output Signal Inversion for CN1-25 and CN1-26 Terminals
0 The signal is not inverted.
1 The signal is inverted.
Sigma-7 Series SERVOPACKs
Parameter and Object Lists
List of Parameters > List of Parameters
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 715