YASKAWA Sigma-7 SGD7S Series - Page 716

n.X
Reserved parameter (Do not change.)
Param-
eter No.
Size Name Setting
Range
Setting
Unit
Default
Setting
Appli-
cable
Motors
When
Enabled
Classifi-
cation
Refer-
ence
Pn514 2 Output Signal
Selections 4
0000h to
0666h
– 0000h All After
restart
Setup –
n.X
Reserved parameter (Do not change.)
n.X
Reserved parameter (Do not change.)
n.X
/PM (Preventative Maintenance Output) Signal Allo-
cation
Reference
0 Disabled (the above signal output is not used).
Ä Chap. 10.5.3
‘Preventative
Maintenance’
page 451
1 Output the signal from the CN1-1 or CN1-2 output
terminal.
2 Output the signal from the CN1-23 or CN1-24
output terminal.
3 Output the signal from the CN1-25 or CN1-26
output terminal.
4 to
6
Reserved setting (Do not use.)
n.X
Reserved parameter (Do not change.)
Param-
eter No.
Size Name Setting
Range
Setting
Unit
Default
Setting
Appli-
cable
Motors
When
Enabled
Classifi-
cation
Refer-
ence
Pn516 2 Input Signal
Selections 7
0000h to
FFFFh
– 8888h All After
restart
Setup –
n.X
FSTP (Forced Stop Input) Signal Allocation Reference
0 Enable drive when CN1-13 input signal is ON
(closed).
Ä Chap. 7.14
‘Forcing the
Motor to Stop’
page 258
1 Enable drive when CN1-7 input signal is ON
(closed).
2 Enable drive when CN1-8 input signal is ON
(closed).
3 Enable drive when CN1-9 input signal is ON
(closed).
Sigma-7 Series SERVOPACKs
Parameter and Object Lists
List of Parameters > List of Parameters
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 716