YASKAWA Sigma-7 SGD7S Series - Page 727

Param-
eter No.
Size Name Setting
Range
Setting
Unit
Default
Setting
Appli-
cable
Motors
When
Enabled
Classifi-
cation
Refer-
ence
Pn603 2 Regenerative
Resistance
0 to
65,535
10 mΩ 0 All Immedi-
ately
Setup
Ä Chap.
6.18 ‘Set-
ting the
Regener-
ative
Resistor
Capacity’
page 194
Param-
eter No.
Size Name Setting
Range
Setting
Unit
Default
Setting
Appli-
cable
Motors
When
Enabled
Classifi-
cation
Refer-
ence
Pn604
*7
2 Dynamic
Brake Resist-
ance
0 to
65,535
10 mΩ 0 All After
restart
Setup
*6
Param-
eter No.
Size Name Setting
Range
Setting
Unit
Default
Setting
Appli-
cable
Motors
When
Enabled
Classifi-
cation
Refer-
ence
Pn61A 2 Overheat
Protection
Selections
0000h to
0003h
– 0000h All After
restart
Setup
Ä Chap.
7.15
‘Overheat
Protec-
tion’
page 261
n.X
Overheat Protection Selections
0 Disable overheat protection.
1
Use overheat protection in the YASKAWA Linear Servomotor.
*7
2 Monitor a negative voltage input from a sensor attached to the
machine and use overheat protection.
3 Monitor a positive voltage input from a sensor attached to the
machine and use overheat protection.
n.X
Reserved parameter (Do not change.)
n.X
Reserved parameter (Do not change.)
n.X
Reserved parameter (Do not change.)
Sigma-7 Series SERVOPACKs
Parameter and Object Lists
List of Parameters > List of Parameters
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 727