Single-Phase, 200-VAC Power Supply Input
Terminal Sym-
bols
Terminal Name Specifications and Reference
L1, L2 Main circuit power
supply input terminals for
AC power supply input
Single-phase, 200 VAC to 240 VAC, -15%
to +10%, 50 Hz/60 Hz
L1C, L2C Control power supply
terminals
AC power supply
Single-phase, 200 VAC to 240 VAC, -15%
to +10%, 50 Hz/60 Hz
DC power supply
L1C: 270 VDC to 324 VDC, -15% to +10%,
L2C: 0 VDC or
L2C: 270 VDC to 324 VDC, -15% to +10%,
L1C: 0 VDC
B1/ , B2, B3
Regenerative Resistor
terminals
Ä
Chap. 5.4.6 ‘Wiring Regenerative Resis-
tors’ page 103
n For SGD7S-R70A, -R90A, -1R6A, and
-2R8A
If the regenerative capacity is insuffi-
cient, connect an External Regenera-
tive Resistor between B1/ and B2.
The External Regenerative Resistor is
not included. Obtain it separately.
n For SGD7S-5R5A, and -120A0A008
If the internal regenerative resistor is
insufficient, remove the lead or short
bar between B2 and B3 and connect
an External Regenerative Resistor
between B1/ and B2.
The External Regenerative Resistor is
not included. Obtain it separately.
1, 2
DC Reactor terminals for
power supply harmonic
suppression
Ä
Chap. 5.4.7 ‘Wiring Reactors for Har-
monic Suppression’ page 106
These terminals are used to connect a DC
Reactor for power supply harmonic sup-
pression or power factor improvement.
- None. (Do not connect anything to this ter-
minal.)
You can use a single-phase, 200-V power supply input with the following models.
n SGD7S-R70A, -R90A, -1R6A, -2R8A, -5R5A
If you use a single-phase, 200-VAC power supply input for the SERVOPACK’s main cir-
cuit power supply, set parameter Pn00B to n.1 (Use a three-phase power supply
input as a single-phase power supply input). Refer to the following section for details.
Ä
Chap. 6.3.3 ‘Single-phase AC Power Supply Input/Three-phase AC Power Supply
Input Setting’ page 144
You do not need to change the setting of Pn00B to n.
1
(Use a
three-phase power supply input as a single-phase power supply input) for
a SERVOPACK with a single-phase 200- VAC power supply input (model
numbers: SGD7S-120A
008).
Sigma-7 Series SERVOPACKs
Wiring and Connecting SERVOPACKs
Wiring the Power Supply to the SERVOPACK > Terminal Symbols and Terminal Names
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 94
To Next Page
Loading...
